Characteristics: A water-borne decorative finish for use on most interior masonry surfaces. With good adhesion giving high coverage area resistance to alkali

Recommended Use: Recommended as a finish coat. Specify for interior drywall, textured drywall, plaster, concrete and masonry. May be applied to primed or previously coated surfaces.

Physical Characteristics

Finish	MATT
Colour	WHITE
Volume Solids	43%±2
Density	1.58kg / L ±0.03
Viscosity	125 KU ± 3
Film Thickness wet/ dry	90 micron / 40 micron
Thinning	If thinning is necessary, thin up to a maximum Of 10% Water
Recommended Coats	Apply 2 coats to appropriately prepared substrate
Theoretical Coverage	10 - 11 m ² /L
Flash Point	------------------

Surface Preparation: Paint only clean, dry surfaces. Remove all grease, oil, wax, or other material by solvent or detergent washing. Remove all loose, flaking or chalking surfaces. New Construction: Dependent on yard procedures, consult your Eagle Representative.

Application Methods: Method: Brush, roller or spray

Drying: Dry time is approx.1/2 hour. The dry time will vary with temperature and humidity. Use when the temperature between 10 – 35 degree centigrade

Packing: 4 kg - 8Litres - 20 kg

Storage & Shelf-life: Minimum 24 months in closed container. Keep container in a well-ventilated area. Close container after each use. Keep lid tightly closed during storage. Protect from direct sunlight and heat. The applicator should obtain more detailed information from the product label.

Health & Safety: Avoid contacts with eyes. Wash hands after use. Please read and observe all precautionary notices on container labels.

DISCLAIMER: The technical data presented in this bulletin are based upon the best available data and practices known to Eagle Paints at the present time. Since Eagle paints is constantly improving its coatings and paint formulas, future technical data may vary somewhat from what was available when this bulletin was printed. Please contact your Eagle Sales Representative for the most up-to date information. Your feedback is important to us. If you have any comments or suggestions regarding our products and services, please share them with us.

Product for application

• For interior
  
  • 2 coat of emultex putty
    
  • One coat of eagle interior primer
    
  • One coat of high emultex emulsion
    
  • 2 coat of super eagle flat or mega emulsion or super eagle silk or eagle plus