|
Characteristics: Due to its superior adhesion to the surface, it has good resistance to wear and tear normally associated with foot and automobile traffic.
Recommended Use: Road marking paint is recommended for use on asphalt and concrete roads.
Physical Characteristics
|
Finish |
flat |
|
Colour |
White , yellow , grey |
|
Solid/volume |
53% |
|
Density |
1.53-1.55kg/L |
|
Viscosity |
6-7 min |
|
Film Thickness
Wet film/ dry film |
1000 micron /530 micron |
|
Thinning |
If thinning is necessary, thin up to a maximum Of 10% Xylene |
|
Recommended Coats |
Apply 1 coats to appropriately prepared substrate |
|
Theoretical Coverage |
1 mē/L |
|
Gloss @ 60 |
2-7 degree |
Surface Preparation: All asphalt to be clean and dry. Remove all grease, oil, wax, or other material. The asphalt must be lift for dry for at least 40 days. The temperature must be not exceed 50degree. The thickness of the wet film must be not less than 1000 micron.
Application Methods: Method: Brush, or spray, roller.
Drying: Dry time is approx 20-25 min. The drying time will vary with temperature and humidity.
Packing: 15 kg pails or drum 200kg.
Storage & Shelf-life: Minimum 12 months in closed container. Keep container in a well-ventilated area. Close container after each use. Keep lid tightly closed during storage. Protect from direct sunlight and heat. The applicator should obtain more detailed information from the product label.
Health & Safety: Avoid contacts with eyes. Wash hands after use. Please read and observe all precautionary notices on container labels.
DISCLAIMER: The technical data presented in this bulletin are based upon the best available data and practices known to Eagle Paints at the present time. Since Eagle paints is constantly improving its coatings and paint formulas, future technical data may vary somewhat from what was available when this bulletin was printed. Please contact your Eagle Sales Representative for the most up-to date information. Your feedback is important to us. If you have any comments or suggestions regarding our products and services, please share them with us.
Product for application:
|
