Characteristics: A water-borne sealer based on P.V.A copolymer . it sealer coat to close any pores in the wall

Recommended Use: Recommended as a sealer coat. Specify for interior and exterior drywall, , plaster, concrete and masonry gypsum; brickwork; rendering, putties

Physical Characteristics

Finish	whitish
Colour	________________________
Solid/valium	23.5% ± 2
Density	1.02 kg/L  ± 0.03
Viscosity by Brookfield viscometer	99 ku  ± 3
Film Thickness / Wet film / dry film	90 micron / 21.8  micron
Thinning	If thinning is necessary, thin up to a maximum Of 10% Water
Recommended Coats	Apply 2 coats to appropriately prepared substrate
Theoretical Coverage	20m ²/L
Flash Point

Surface Preparation: All surface to be clean. Remove all grease, oil, wax, or other material by solvent or detergent washing. Remove all loose, flaking or chalking surfaces. New Construction: Dependent on yard procedures, consult your Eagle Representative.

Application Methods: Method: Brush, roller or spray

Drying: Dry time is approx.1/2 hour to be recoat after 3-4 hours and full cure overnight. The dry time will vary with temperature and humidity. Use when the temperature between 10 – 35 degree centigrade

Packing: Drum 10 litre

Storage & Shelf-life: Minimum 12 months in closed container. Keep container in a well-ventilated area. Close container after each use. Keep lid tightly closed during storage. Protect from direct sunlight and heat. The applicator should obtain more detailed information from the product label.

Health & Safety: Avoid contacts with eyes. Wash hands after use. Please read and observe all precautionary notices on container labels.

DISCLAIMER: The technical data presented in this bulletin are based upon the best available data and practices known to Eagle Paints at the present time. Since Eagle Paints is constantly improving its coatings and paint formulas, future technical data may vary somewhat from what was available when this bulletin was printed. Please contact your Eagle Sales Representative for the most up-to date information. Your feedback is important to us. If you have any comments or suggestions regarding our products and services, please share them with us.

Product for application

• For interior
  
  • One coat of eagle emultex sealer
    
  • 2 coat of emultex putty
    
  • One coat of eagle interior primer
    
  • One coat of high emultex emulsion
    
  • 2 coat of super eagle flat or mega emulsion or super eagle silk or eagle plus